Xilinx Firmware
Latest PMC Firmware schematic:
PMC_Top.pdf
Latest PMC Firmware files (FW Rev 1.0):
FW_PMC_GabSWPassThruRev1_0.zip
6 cables are required for this setup.
Mapping of all connections: ConnectionsToOldFPIX2i.pdf
SAMTEC Cables
Three cables are needed to connect the PMC SAMTEC "A", "B", and "C"
headers to the PMC Connector Adapter Board SAMTEC "A", "B", and "C" headers,
respectively. See image below:
Cables to PreFPIX2i old innerboard
Use the JC1, JC2, and JC3 connectors on the PMC Connector Adapter Board to connect to the PreFPIX2i old innerboard as shown below:
**NOTE: Make sure J9 and J10 jumpers are installed on the PMC Connector Adapter Board. These images do not show them installed. This connects the PMC GND to the PreFPIX2i old innerboard GND.
